assignment help,assignment help service,assignment writing service

Civil Engineering Assignment Help

Building and Construction Assignment (Surveying Questions and Solutions)

CPCCBC5006B Apply site surveys and set-out procedures to medium rise building projects.

Knowledge Assessment (Written Tasks)

Q.1. What is a site datum?

Q.2. List 4 ways to ensure health and safety whilst undertaking levelling.

Get solutions for full assignment. Contact me

Q.3. Identify the components of the WILD automatic level with fixed and suspended prisms:

Q.4. Outline a process to check the accuracy of a spirit level.

Q.5. What should be done at time of clean up after levelling?

Q.6. What is a levelling staff?

Q.7. Explain the static staff method.

Q.8. While undertaking levelling activities, what should you think about in terms of the environment?

Q.9. Outline the process for reading the staff when taking levels.

Get solutions for full assignment. Contact me

Q.10. Write a procedural summary for undertaking detail surveys.

Q.11. How would you set up an automatic level?

Q.12. List the steps for sighting to take levels.

Q.13. List 3 Levelling devices and their advantages and disadvantages.

Q.14. When and where should the following sign be used?

Q.15. How would you measure distance and what is the measured distance from the sighted reading below?

Q.16. What is a Line of Collimation?

Q.17. Outline how to use a water level.

Q.18 (a). Define the terms as below:

Q18 b. What does the diagram below show?

Q.19. What is the reading shown below?

Q.20. A line of levels is run from BM10 to BM11. At BM10 the elevation is 101.325 m in the Australian Height Datum (AHD). The following observations were taken:

All the level setups are equally distant between back- and foresights to reduce error. Use the rise and fall method to work out the levels in order to find the elevation of BM11.

Q. A line of levels is run from BM104 to BM105. At BM104 the elevation is 692.123 m in the Australian Height Datum. The backsights and foresights are as follows.

Use the rise and fall method to work out the levels in order to find the elevation of BM105 (foresight at D).

Get solutions for full assignment. Contact me

Q.21. The staff readings, as shown below, were obtained in a leveling exercise. Tabulate the data in a leveling form and calculate the adjusted reduced levels of P, Q, and R using the rise and fall method. All mathematical checks are to be included. The staffs at R and Q were held inverted.

Q.22. This was run in two directions. Fill out the observation form (backsights, foresight, and intermediate sights) and reduce the observations using the collimation height method.

Q.23 A two-peg test of a level produced the following results:

Given that the distance A to B is 60 m, calculate the sign and magnitude of the collimation error.

Get solutions for full assignment. Contact me

Q.24 Levels were taken at 25 m intervals along the centreline of the proposed work. If the formation is to have a gradient of -1% starting at elevation 222.92 m at Peg K, calculate the amount of cut (-) or fill (+) required at each peg. Use the collimation height method of reduction.

Q.25. List tools used for setting out.

Q.26. What is a survey peg?

Q.27. Describe what a boundary is.

Q.28. Describe a hurdle.

Q.29. Why do you keep the hurdle level?

Q.30. Explain why is it important that measurements be taken on a horizontal plane.

Q.31. Sketch a means of measuring a horizontal distance down a sloping site.

Get solutions for full assignment. Contact me

0/5 (0 Reviews)

Give a Comment

Ad Blocker Detected

Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker.